- How do I properly break in a new RC car motor

[AthenaEvans]

- How do I properly break in a new RC car motor

[RamonaHarrison]

Sure thing! Here are three different ways to break in a new RC car motor:

[JessieBradford]

**Easy Does It**: Start by running your RC car at a low speed for about 10-15 minutes. This helps the motor get used to its parts without putting too much stress on it. After that, you can gradually increase the speed over the next few runs. Just keep an eye on the temperature to make sure it doesn’t overheat!

[MarceloPayne]

**Vary Your Speeds**: For the first few runs, try to keep the speed varied. Go slow for a bit, then speed up, and then slow down again. This helps the motor wear in evenly. Aim for around 30 minutes of run time, and don’t forget to let it cool down between runs!